Data Sheet no28-2015.
PRODUCT DESCRIPTION: |
A general purpose interior/exterior solvent based varnish for all wood surfaces.
USES: |
- For use on new and previously varnished interior and exterior wood surfaces.
FEATURES: |
- Excellent water resistance.
- Excellent exterior durability and very UV resistant.
- Durable wood varnish for all wood surfaces.
PRODUCT INFORMATION: |
- Type: A Long Oil Alkyd.
- Appearance: Matt and Gloss.
- Colors: Clear, Light Oak, Dark Oak, Teak, Mahogany.
- Solids: 45% by mass.
- Density: 0.82 – 0.86.
- Specific Gravity: 0.90 – 0.91.
- Viscosity at 25ºC: 65-70 Kµ.
- Flash Point: Flammable at 34ºC.
APPLICATION DETAILS: |
- Mixing: Stir well before use.
- Method: Brush. Rollers not recommended. Conventional spray.
- Thinning: Mineral Turpentine.
- Clean up: Mineral Turpentine.
- Spreading rate: 10-12m ²/l depending on surface porosity and profile.
- Conditions: Avoid painting in wet or cold weather. Minimum temp 8º C
- Drying time: Touch dry 4 hours. Hard dry 18 hours at 25 degrees.
- Recoating time: 18 hours.
- Requirements: 2 coats.
SURFACE PREPARATION: |
- New Surfaces must be sound, clean and dry (moisture content below 15%) before painting.
- Sand to a smooth surface in the direction of the wood fiber.
- Remove all dust.
- Thin first coat with 10% Mineral Turpentine.
- Sand slightly with fine sandpaper or fine steel wool in between coats.
- Apply 2nd coat and 3rd coat unthinned.
- To prevent ingress of moisture the end grain must be coated..
- Redecoration.
- For surfaces in poor condition: Strip down and treat as new work.
- Surfaces in good condition must be slightly sanded, dusted and then treated as new work.
- For maximum protection on exterior wood 3 coats of varnish is advisable.
STORAGE: |
- Keep containers properly sealed.
- Store away from direct heat, sun and severe cold.
PACKAGING: |
- 1 Liter, 5 Litres, 20 Litres.
PRECAUTIONS: |
- Detailed safety information: refers to the material safety data sheet for this product.
- Not to be used as a wood floor coating.
- Do not apply on wet or damp timber.
- Do not paint in wet or cold weather. (Minimum 5ºC.)
- Drying times will be extended during wet or cold weather conditions
- To prevent ingress of moisture the end grain must be coated..