Versus Super High Gloss Enamel

Printable PDF: Versus Super High Gloss Enamel

VGE

PRODUCT DESCRIPTION:

 

Top quality tough, traditional, solvent and oil based interior exterior high gloss enamel.

 

USES:

 

• Final coat for interior and exterior cement plaster, wood, metal.
• Previously painted surfaces in sound condition.
• Easy to clean due to low dirt retention.
• Ideal for use on high traffic areas or surfaces that may require frequent washing.
• Very tough and hardwearing.
• Ideal for painting doors, windows.

 

FEATURES:

 

• Easy to keep clean.
• Very tough and hardwearing.
• Lead free.
• Excellent exterior durability.
• Good color stability.
• Very good opacity, stain resistance and wash ability.

 

PRODUCT INFORMATION:

 

• Type: Long Oil Alkyd.
• Appearance: High Gloss.
• Colors: White and a range of colors. Pastel, Medium and Deep tone colors can be tinted on request.
• Solids: 64 – 66% by mass.
• Density: 1.08 – 1.20.
• Recommended Dry Film Thickness: Minimum 20 µm and maximum 30µm.
• Specific Gravity: 1.08 – 1.2.
• Viscosity at 25ºC. : 65 -70 Krebs µ.
• Flash Point: 34ºC.

 

APPLICATION DETAILS:

 

• Mixing: Stir well before use.
• Method: Short nap mohair roller or brush.
• Thinning: Do not thin.
• Clean up: Mineral Turpentine.

• Spreading rate: 8 – 10 m ²/l depending on surface porosity and profile.
• Conditions: Avoid painting in wet or cold weather. Minimum temp 8º C

• Drying time: Touch dry 4 hours. Hard dry 18 hours at 25 degrees.
• Recoating time: 18 hours.
• Requirements: 2 coats.

 

SURFACE PREPARATION:

 

• New Surfaces must be sound, clean and dry before painting.

 

• Concrete and cement: Prime with 1 coat Versus Plaster Primer followed with 1 coat of Versus Universal Undercoat before applying the topcoats..
• Wooden surfaces should be primed with Versus Pink Wood primer and followed with Versus Universal Undercoat.
• Galvanized Iron should be cleaned first with Versus Galvanized Iron Cleaner until a water break free surface has been achieved. Thereafter prime with Versus Galvanized Iron Primer and followed with Versus Universal Undercoat.
• Rusted Metals should be wire brushed or sanded to remove all rust. Prime with Versus Steel Primer. Thereafter apply Versus Universal Undercoat.
• PVC gutters and downpipes should be degreased and then abraded with fine sandpaper. Apply the topcoat.

 

• Previously Painted Surfaces must be sound, clean and dry before painting.

 

After all surfaces are sound, clean and dry apply one coat of Versus             Universal Undercoat as a tie coat. Other areas that have chalked and are powdery should be well sanded and sealed with Versus Plaster Primer.

 

STORAGE:

 

• Keep containers properly sealed.
• Store away from direct heat, sun and severe cold.

 

PACKAGING:

 

• 1 Liter and 5 Litres. (20 Litres on request).

 

PRECAUTIONS:

• Detailed safety information: refers to the material safety data sheet for this product.
• Do not apply directly to bare surfaces.
• Do not paint in wet or cold weather. (Minimum 5ºC.)
• Drying times will be extended during wet or cold weather conditions.
• Application must be even to prevent variations in gloss levels.
• Yellowing will occur with time in dark areas.